Get in touch
Call 17374503767 to reach us directly. We're based at 1202 Lakeway Dr, Lakeway, TX 78734, which puts us close to the neighborhoods we work in most - Point Venture two miles off, Bee Cave at four, Briarcliff and Hudson Bend at five.
If you're calling about a door that won't close, have the make of your opener handy if you know it; it saves time on the phone. We also cover Lago Vista, Barton Creek, Lost Creek, Jonestown, West Lake Hills, Belterra, Bear Creek, Dripping Springs, Sunset Valley, Shady Hollow, Driftwood, and Manchaca, along with Travis Settlement, Apache Shores, Steiner Ranch, and Highland Lake Estates.
That's a wide stretch of the Hill Country, and drive time varies a lot depending on which side of the lake you're on, so when you call we'll give you a realistic window rather than a guess.
We don't run a 24-hour dispatch line, so if you call after hours, leave a message and we'll get back to you the next business day. For anything that can wait until morning - a noisy roller, a slow opener - that's the better route anyway.
What to expect
When you call, we ask what the door is doing: won't open, won't close, stuck halfway, making a noise it didn't used to make. That tells us whether it's a spring, a cable, a track out of alignment, or an opener board that's failing.
Most houses in this area went up between 1980 and 2014, with a lot of that stock dating to the early 2000s, so we're usually looking at torsion spring systems and openers from that same window rather than the older extension-spring setups you'd find in an older part of town.
We'll ask roughly how old the door and opener are, since that narrows down what parts we bring. If your opener is one of the common models installed across the 2000s-era builds in Lakeway and the surrounding communities, we likely already carry the part on the truck. If it's something less common, we'll tell you that up front instead of showing up and guessing.
We give you a time window, not an exact minute, because of how spread out the service area is - a job near Point Venture and one near Dripping Springs aren't the same drive. Once we're at the house, we diagnose before we quote, and we tell you if a repair isn't worth it compared to replacing the door.
Our services
Serving Lakeway, TX
We work on torsion and extension springs, cables, rollers, tracks, and openers - the parts that fail on doors installed across the 2000s and 2010s building boom this area saw. With housing stock concentrated in that 1980-2014 range across the sixteen named communities we serve, we see a lot of the same opener brands and door hardware repeated house to house, which keeps parts on hand more often than not.
We don't do new garage construction or structural framing - if a door opening needs to be built out or widened, that's a carpentry job, not ours. We also don't install doors that need custom sizing outside standard residential widths; we'll tell you if that's what you're dealing with.
Given the area's moderate heat profile, we see more wear on weatherstripping, nylon rollers, and opener logic boards from heat cycling than from cold-weather failures. That's a different failure pattern than you'd get in a colder climate, and it shapes what we stock and what we check first on a service call. If your door is original to a 2001-era build, we'll look closely at the torsion spring winding cones - that's often the first thing to go on hardware that old.
Questions
Yes. Most homes in the Lakeway area were built between 1980 and 2014, with a lot of that stock from the early 2000s, so we see a mix but lean toward torsion systems from that era. We carry parts for both and will tell you which type you have if you're not sure.
We cover the surrounding Hill Country communities, from Point Venture two miles away out to Manchaca at eighteen. Drive time depends on which side of the lake you're calling from, so we'll give you a realistic window when you call rather than a fixed appointment time.
No. That's structural carpentry work, not something we take on. We handle the door, opener, and hardware itself. If your project needs the opening resized, we'll tell you that up front so you can line up the right trade.
Given the housing stock's age and the moderate heat here, we see a lot of worn weatherstripping, dried-out rollers, and opener boards that fail from heat cycling rather than cold. On original 2001-era doors, the torsion spring winding cones are often the first thing to wear out.
Ready when you are
Lakeway Garage Door Pros repairs and installs garage doors, springs and openers in Lakeway, TX and the surrounding area.
